Troubleshooting; Specifications - Stanley BC1509 Instruction Manual

2. Press the battery recondition button. The LCD screen will display the following:
The bars on the battery icon will change from solid to empty (top to bottom) repeatedly and the icons pointing to the "+" and "–" flash.
IMPORTANT: If 5 cycles of reconditioning does not improve battery performance, discontinue and recycle the battery.
When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp from battery terminal.
Using the Quick Start Timer™
1. Set up the battery charger and connect to the battery following steps 1 through 5 in the "Charging the Battery" section.
2. Press the Quick Start Timer™ button. The LCD screen will display the following*:
The digital display shows the countdown. The bars on the battery icon will change from empty to solid (bottom to top) repeatedly and the
arrow logos pointing to the "+" and "–" flash.
*The countdown will commence from "3" to "0" on the BC4009CA; from "5" to "0" on the BC2509CA; or from "8" to "0" on the BC1509CA.
3. When "0" is reached, the "pump engine" icon ( ) will begin flashing for two minutes. The vehicle is ready to start.
4. Crank the engine using manufacturer' s guidelines, typically in 3 to 5 second bursts. The function requires a resting/cooling period between
attempts. Wait 4 to 5 minutes before a second attempt at starting the engine, if needed.
Two minutes after the "pump engine" icon flashes, the charger automatically reverts to charging mode. To stop charging, press the charge button.
When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp from battery terminal.

TROUBLESHOOTING

Unit Not Charging
• Check that the charger is properly connected to a live 120 volt AC outlet.
• If the battery to be charged has fallen below 2 volts, the battery cannot be recharged with these chargers.
CARE AND MAINTENANCE
Storage
• Store the unit in a clean, dry, cool place when not in use.
• Clean the unit casing and cords (as necessary) with a dry (or slightly damp) cloth. Ensure that unit is completely disconnected from battery and
power source before cleaning.
• To maintain the operating condition and maximize the life of the charger cords, always coil them loosely for storage. Do not wrap them around
the unit or crimp them with a tight band.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding
accessories, please contact manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at (877) 571-2391.
FIVE-YEAR LIMITED WARRANTY
Manufacturer warrants this product for five years against any defects in material or workmanship. The defective product will be replaced or
repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased (provided that the store is a
participating retailer). Returns should be made within the time period of the retailer' s policy for exchanges (usually 30 to 90 days after the sale).
Proof of purchase may be required. Please check with the retailer for their specific return policy regarding returns that are beyond the time set for
exchanges. The second option is to return the product (prepaid) to the manufacturer for repair or replacement at our option. Proof of purchase
may be required.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other rights which vary from state to
state or province to province. This product is not intended for commercial use.
8

SPECIFICATIONS

BC1509CA
Input: 120VAC, 60Hz, 4A
Output: 12VDC, 15A
Imported by
Baccus Global
399 NW 2nd Avenue, Suite 150,
Boca Raton, FL 33432
(877) 571-2391
BC2509CA BC4009CA
120VAC, 60Hz, 6.5A 120VAC, 60Hz, 9.5A
12VDC, 25A 12VDC, 40A
RD071210
9