Toshiba RAS-13SKHP-E Service Manual page 37

8-4-4. Piping and drain hose installation
<Piping and drain hose forming>
* Since dewing results in a machine trouble, make
sure to insulate both the connecting pipes. (Use
polyethylene foam as insulating material.)
Rear right
Rear left
Bottom left
Left
Bottom right
Right
1. Die-cutting front panel slit
Cut out the slit on the left or right side of the front
panel for the left or right connection and the slit
on the bottom left or side of thefront panel for the
bottom left or right connection with a pair of
nippers.
2. Changing drain hose
For leftward connection, bottom leftward connection
and rear leftward connection's piping, it is necessary to
change the drain hose and drain cap.
How to remove the drains cap
Clip drain cap by needle-nose plier, and pull out.
Fig. 8-4-10
How to install the drain hose
Firmly insert drain hose connecting part until hitting on
a heat insulator and fix it with a screw.
Heat insulator
Drain hose
How to remove the drain hose
The drain hose can be removed by take off screw,
•
after that twisting and pulling.
When removing the drain hose, be careful of any sharp
•
edges of steel plate. The edges can cause injuries.
How to fix the drains cap
1) Insert hexagonal wrench (4 mm) in a center
2) Firmly insert drains cap.
<In case of right or left piping>
• After scribing slits of the front panel with a knife or a
<In case of bottom right or bottom left piping>
• After scribing slits of the front panel with a knife or a
Fig. 8-4-11
− 36 −
head.
4 mm
Fig. 8-4-12
No gap
Insert a hexagon
wrench (4 mm)
Fig. 8-4-13
CAUTION
Firmly insert the drain hose and drain cap; otherwise,
water may leak.
making-off pin, cut them with a pair of nippers or an
equivalent tool.
Slit
Fig. 8-4-14
making-off pin, cut them with a pair of nippers or an
equivalent tool.
Slit
Fig. 8-4-15
FILE NO. SVM-07033
Do not apply lubricating oil
(refrigerant machine oil) when
inserting the drain cap.
Application causes deterioration
and drain leakage of the plug.