LENCO LED-2215 Instruction Manual page 25

1.1.1.2 Transponder
You can select the current Transponder or add the new Transponder.
1.1.1.3 Local Frequency
You can change the local frequency.
Note: You must press OK to save this local frequency when the cursor is on the Local
Frequency item before you select another satellite.
1.1.1.4 22K Tone
You can change the 22k tone. Press LEFT/RIGHT select ON, OFF or AUTO.
Note: You must press OK to save this 22K tone when the cursor is on the 22K Tone item
before you select another satellite.
1.1.1.5 Polarity
You can change the polarity. Press LEFT/RIGHT select 13V, 18V, 13/18V or OFF .
Note: You must press OK to save this polarity when the cursor is on the Polarity item before
you select another satellite.
1.1.1.6 DiSEqC Switch
You can change DiSEqC Switch. Press LEFT/RIGHT select LNB1, LNB2, LNB3, LNB4 or
OFF.
Note: You must press OK to save this DiSEqC Switch when the cursor is on the DiSEqC
Switch item before you select another satellite.
1.1.1.7 Antenna mode
You can change the Antenna mode. Press LEFT/RIGHT select Fixed, Goto x or DiSEqC1.2.
When you select Goto x: :
Press OK to enter the submenu of the Adjust Antenna .
Press UP/DOWN to move the curser to the item of the Transponder.
Press LEFT/RIGHT to select the current transponder.
Press UP/DOWN to move the curser to the item of the Satellite Longitude.
Input the data of the Satellite Longitude and press LEFT/RIGHT select East or West.
Press UP/DOWN to move the curser to the item of the My Longitude.
Input the date of the My Longitude and press LEFT/RIGHT select East or West.
Press UP/DOWN to move the curser to the item of the My Latitude.
Input the date of the My Latitude and press LEFT/RIGHT select South or North .
Press UP/DOWN to move the curser to the item of the Goto Position.
Press OK to move the Antenna to the position you want.
23