Pipe Thermostat; Handover; Specification; Technical Data - Stanley Erin Installation And Operating Instructions Manual

PIPE THERMOSTAT

The fitting of a pipe thermostat to the flow pipe is
essential in order to activate the water circulation
pump when the water reaches the selected
temperature.
When the water temperature falls below the select-
ed temperature the pipe thermostat will cut off the
water circulation pump in order to allow the boiler to
recover.
Fig.19
Note: Dimensions stated are in millimetres unless otherwise stated and may be subject to a slight +/- variation.
Nominal Output
Manufactured
Smokeless Fuel
Typical refuelling intervals to obtain nominal out-
puts
Flue Gas Mass Flow
Flue Gas temp at nominal output
Gross Weight: 178 kgs
Max operating water pressure 2 bar
Flue Outlet
This appliance has been tested in
accordance with BS EN 13240
367
588

TECHNICAL DATA

Room 5.0kW
Water 7.3kW
153 mm

HANDOVER

On completion of the installation allow a suitable
period of time for any fire cement and mortar to dry
out, when a small fire may be lit and checked to
ensure the smoke and fumes are taken from the
stove up the chimney and emitted safely to the
atmosphere. Do not run at full output for at least 24
hours.
Ensure that the operating instructions for the stove
are left with the customer. Ensure to advise the cus-
tomer on the correct use of the appliance with the
Fig.18
fuels likely to be used on the stove and warn them to
use only the recommended fuels for the stove.
Advise the user what to do should smoke or fumes
be emitted from the stove. The customer should be
warned to use a fireguard to BS 6539 in the pres-
ence of children, aged and/or infirm persons.

SPECIFICATION

743
Nominal Output
Wood logs
Wood
MSF
MSF
Wood logs
o
330 C
Boiler capacity 9.3 litres
Boiler tappings 1" BSP
Log size
11
567
284
Room 3.6kW
Water 7.5kW
1.5 hours
4 hours
9.2 g/s
6.7 g/s
406 mm
125