InFocus SP-CEIL-UNIV Installation And Assembly Manual page 9

Flip projector upside down. Find your projector from the models listed below. Using the holes indicated on the corre-
sponding hole pattern diagram, attach adapter plate (R) to projector using three M4 x 16 mm serrated socket pin
screws (H) and three .198 x .313 x .375 retaining spacers (J).
Notes:
Retaining spacers go between adapter plate and projector.
* Front of projector.
** Projectors using hole pattern G use one M4 x 12 mm screw (I) and one .198 x .313 x .187 retaining spacer (K)
where indicated.
*** Using holes indicated in hole pattern H, attach adapter plate (R) to projector using four M6 x 12 mm serrated
socket pin screws (O) and four spacers (L)
A. C200, DP6500X, LP650, SP5700,
SP7200, SP7205, SP7210
*
R
D. C100, C105, DP6150, DP6155,
LP690
*
R
G. C160, C180, LP540, LP640,
SP5000
*
R
Visit the InFocus Web Site at www.infocus.com
B. C40, C50, DP2000S, DP2000X,
LP240, LP250
E. C109, C110, DP8000, LP790,
SP4800, SP4805, X1, X1a, X2, X3
H. C440, C450, C460, DP8400X,
DP8500X, LP840, LP850, LP860
S
***
**
***
*
R
*
R
S
* ***
R
***
9 of 11
C. LP340, LP350, LP500, LP530,
SP110
*
R
F. C170, LP600
*
R
I. C410, C420, LP815, LP820,
DP8200X
*
R
ISSUED: 10-22-04 SHEET #: 055-9236-5 01-10-06