In these operating instructions, the designation “the ap- Always keep these operating instructions to- pliance” always refers to the SDT 5 stand-up decking gether with the appliance. fastening tool. Ensure that the operating instructions are...
The type designation and the serial number are stamped on the rear of the appliance. Make a note of this data in your operating instructions and always refer to it when making an enquiry to your Hilti representative or service department. Read the...
Release the two wing nuts on the main module. struction screwdriver. Push the two grips into the lower tubular sections. Fit the bit holder and socket to the Hilti metal con- Adjust the height and angle of the grips. In order struction screwdriver.
7.6 Removing screws from the magazine 11 Plug the power tool’s supply cord into the electric Push the empty magazine strip back into the appli- socket or fit the battery to the Hilti metal construction ance. screwdriver. Turn the appliance upside down, i.e. the nosepiece points upwards.
9 Disposal Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative for further information.
Page 11
This constitutes Hilti’s entire obligation with regard to warranties. warranty and supersedes all prior or contemporaneous...