Table of Contents
Advertisement
and vice versa in response to oncoming traffic,
traffic ahead of you, and adequate ambient
lighting, e.g. on city streets.
Switching the high beams on and off
manually
Whenever you wish, or when the situation
requires, you can intervene:
>
If the High-beam Assistant switches on the
high beams, but you would like to drive with
the low beams, simply switch off the high
beams using the turn signal/high beam
lever. This deactivates the High-beam
Assistant.
To reactivate the system, briefly push the
turn signal/high beam lever toward the high
beams again.
>
If the High-beam Assistant switches on the
low beams, but you would like to drive with
the high beams, switch on the high beams
as usual. This deactivates the system and
the high beams need to be switched off
manually, if necessary.
To reactivate the system, briefly push the
turn signal/high beam lever toward the high
beams again.
>
Use the headlamp flasher as usual with the
low beams switched on.
System limitations
The High-beam Assistant cannot serve
as a substitute for the driver's personal
judgment of when to use the high beams.
Therefore, manually switch off the high beams
in situations where this is required to avoid a
safety
risk.<
The system is not fully functional in situations
such as the following, and driver intervention
may be necessary:
>
In very unfavorable weather conditions,
such as fog or heavy precipitation
>
In detecting poorly-lit road users, such as
pedestrians, cyclists, horseback riders and
wagons; when driving close to train or ship
traffic; and at animal crossings
Online Edition for Part no. 01402911223 - © 06/13 BMW AG
Lamps
>
In tight curves, on hilltops or in depressions,
in cross traffic or half-obscured oncoming
traffic on highways
>
In poorly lit towns and cities and in the
presence of highly reflective signs
>
At low speeds
>
When the windshield in front of the interior
rearview mirror is fogged over, dirty or cov-
ered with stickers, etc.
>
If the sensor is dirty. Clean the sensor on
the front of the interior rearview mirror using
a cloth moistened with a small amount of
glass cleaner.
Activating via iDrive
1.
"Settings"
2.
"Lighting"
3.
"High beam assistant"
The setting is stored for the remote control
currently in use.
Fog lamps
To switch on/off, press the button.
Controls
103
Advertisement
Table of Contents
