Table of Contents
Advertisement
APPENDIX
APPENDIX
TROUBLESHOOTING
Problem
Power does not turn
on.
The camera does not
take pictures.
Image is not recorded
when the shutter
button is pressed.
The flash does not
fire
Image is blurry or out
of focus.
Image is not
displayed on the LCD
monitor.
Recorded images are
not saved in memory.
Cannot transfer
images to a computer
after connecting the
USB cable.
Cause
Battery is inserted in the wrong
direction.
Batteries are dead.
The battery compartment door
is open.
The flash is charging.
Memory is full.
Memory card is not formatted
correctly.
The Flash is charge.
Memory is full.
Flash is set to OFF.
The camera was moving when
the image was captured.
The subject was beyond the
range within which the camera
can focus.
A memory card with non-DCIF
images (recorded with other
camera) is loaded.
The camera was turned
off/powered down before the
image was stored in memory.
USB driver is not installed.
Reload battery in the correct direction.
Replace or recharge batteries.
Make sure the battery compartment door
is securely closed.
Wait for the flash to charge.
Insert a new memory card.
The card may be detective, use a new
card.
Wait for the flash to charge.
Insert a new memory card.
Set the flash to any mode except off.
Hold the camera steady when shooting
picture.
Turn the Macro mode on it the subject is
within 5 cm (zoom out) or 50 cm (zoom
in). Do not use Macro mode when
shooting distant subjects.
This camera cannot display non-DCIF
images.
If the battery low indicator appears on
the LCD monitor, replace the battery
immediately.
Install the USB driver before you
connect the camera to a computer / turn
the camera on.
45
Solution
Advertisement
Table of Contents
