Install Range Hood - IKEA Vented Range Hood Installation Instructions And Use & Care Manual

3. Use saber or keyhole saw to cut a 7" (17.8 cm) diameter
opening.
*5"
(12.7 cm)
*From wall, not
cabinet frame
4. Install vent through the vent opening in upper cabinet or wall.
Complete venting system according to the selected venting
method. See "Venting Requirements" section.
5. Use caulking to seal exterior wall or roof opening around the
cap.

Install Range Hood

1. Remove terminal box cover.
A. Terminal box cover
2. Depending on your installation remove either back or top
wiring knockout.
A
A. Wiring hole knockouts
8
7 ¹/₄" (18.4 cm) diam.
cabinet cutouts
A
3. Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
A
A. Keyhole slot
4. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.
A. Drill pilot hole
5. Install the four #10 x ⁵⁄₈" mounting screws in pilot holes.
Leave about ¹⁄₄" (6.4 cm) space between screw heads and
cabinet to slide range hood into place.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
6. For Direct Wire Installations:
Install a UL listed or CSA approved strain relief.
A. UL listed or CSA approved strain relief
Pull about 12" (30 cm) of wire through wall or cabinet and
into opening.
For Power Supply Installations:
Follow instructions included with power supply cord kit
marked for range hoods.
A
¹⁄₄"
(6.4 mm)
A