Install Range Hood - IKEA LBZ8C Installation Instructions And Use & Care Manual

Style 3 - Cut Openings for 7" (17.8 cm) Round Vent
To make a circular vent openings on the underside of the
cabinet top and bottom:
1. Mark a centerline on the underside of the top of cabinet.
2. Mark a line distance "A" from the back wall on the underside
of the top and bottom of cabinet.
3. Use a compass or a circle template to draw a circle with a
diameter that is ¼" (0.64 cm) larger than the vent.
4. Use saber or keyhole saw to cut the circular vent opening.
*A
*From wall, not
cabinet frame
"
A. 5 (12.7 cm) for 12
³⁄₈
"
8 (21.3 cm) for 15
Install Extension Panel for 15" (38.1 cm) Deep Cabinets
IMPORTANT: For 15" (38.1 cm) deep cabinets, an IKEA
panel is required. See the "Assistance or Service" section to order
®
the IKEA 30" (76.2 cm) extension panel (IKEA
822-39).
1. Install the extension panel to the wall, use 3 screws and
hardware (purchased separately) appropriate for your type of
wall. Use the installation instructions that come with the
extension panel.
Install Vent System
1. Install vent through the vent opening in upper cabinet or wall.
Complete venting system according to the selected venting
method. See "Venting Requirements" section.
2. Use caulking to seal exterior wall or roof opening around the
cap.
10
"
(30.5 cm) deep cabinets
"
(38.1 cm) deep cabinets
®
extension
®
part number 302-

Install Range Hood

1. Remove the 7" (17.8 cm) round vent mounting plate and the
3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular vent damper on the
inside your range hood.
A
A. 7" (17.8 cm) round vent mounting plate
B. Screws
¹⁄₄
C. 3 " x 10" (8.3 x 25.4 cm) rectangular vent damper
2. Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
A
A. Keyhole slot
3. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.
A. Drill pilot hole.
4. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot
holes. Leave about ¹⁄₄" (6.4 mm) space between screw heads
and cabinet to slide range hood into place.
C
B
A
¹⁄₄"
(6.4 mm)