Proper Care Of Your Infinity Upright Vacuum - Infinity NV29 Owner's Manual

Proper Care of Your Infinity Upright Vacuum
For proper care, consult the table to the
right for the maintenance schedule of
your Cyclonic Chamber and Filters.
Lock vacuum into upright position.
Turn vacuum off.
CAUTION:
Unplug the vacuum;
failure to do so
might result in
electric shock.
Remove Dust Cup Assembly.
1
2
3
Component
1 Cyclonic Chamber
2 Foam and Felt Filters (2)
3 HEPA Filter
1 Cleaning the Cyclonic Chamber:
Twist Cyclonic Chamber to the left (counter clockwise) to unlock and separate from
Dust Cup (a).
Press Cyclonic Chamber Release Button to open the bottom door (b).
Gently tap open Cyclonic Chamber over trash receptacle to release dust and then
close chamber door.
Position Cyclonic Chamber onto Dust Cup; line up the solid arrows on the back (c).
Twist Cyclonic Chamber to the right (clockwise) until the top solid arrow lines up with
the bottom open arrow (d) to lock.
a
2 Washing the Foam and Felt Filters:
Remove the Foam and the Felt Filters from the Filter Holder.
Rinse in lukewarm water until water runs clear.
Squeeze filters and let air dry for 24 hours before replacing; do not use hairdryer or
other heating methods to dry. Insert replacement filters while others are drying.
DO NOT operate the vacuum without ALL the filters in place.
DO NOT operate vacuum with WET filters.
3 Cleaning the HEPA Filter:
Lift up the Foam/Felt Filter Holder to access the HEPA Filter.
Lift out the HEPA Filter Unit.
Tap vigorously against a firm surface to dislodge residual dust particles.
NOTE: Your white Foam, Felt,and HEPA Filters will discolor over time; this is normal
and will not affect the performance of the filters.
Date Purchased:
Maintenance Schedule
Empty every 3 to 5 months, under normal use
Wash every 3 to 5 months, under normal use
Tap clean every 3 years for optimum performance
b
c
d
www.infinityvac.com 11