Infinity NV29 Owner's Manual page 16

To replace new Belt:
Slide one end of the new Belt over the
motor-driven shaft (e).
Slide second end of the Belt around
Brush Roll (f).
f e
f f
Partially insert the right end of the roller
into one side holder (g).
Partially insert the left end into the other
side holder (h).
h
Push both ends all the way into the side
holders at the same time.
Center Belt on motor-driven shaft; test
Brush Roll for easy turning.
Line up the 4 tabs on the Belt and Brush
Roll Cover with the slots on the Power
Nozzle (i); push into place.
g
Turn the three locking screws clockwise
(j) to tighten.
Cleaning the Pet Hair Power
Brush
Slide locking latch (k) forward.
Gently tilt brush housing upward to open.
IMPORTANT: DO NOT force; it will not
open all the way.
Remove debris from turbine wheel and air
passage.
Ordering Replacement Parts
To order additional parts and accessories,
go to www.infinityvac.com or call
1-888-668-9600. Note: some parts may
be available at your local Infinity retailer.
Part
Motor Belt
Headlight Bulb
Foam and Felt Filters
HEPA Filter
i
Telescopic Wand
Detachable Handle
Super Stretch Hose
Upper Hose Holder
Crevice Tool
Upholstry/Dusting Brush
Pet Hair Power Brush
j
Low Reach Bare Floor Brush
www.infinityvac.com
k
Part No.
1102-FP
1088-FP
1083-FP
1082-FP
1121-FP
1119-FP
1120-FP
1086-FP
1084-FP
1097-FP
15