Mailing Service; Event Setting - Samsung SDE-4001 User Manual

using the DVR

Mailing Service

You can send an e-mail to a DVR-registered user at a specific time interval, or if an event occurs.

M
If an event occurs with a channel where the camera's video is set to <OFF> or the remaining recording count is set
to <OFF>, only the text notification will be sent to the applicable email address.

The e-mail receivers are not able to adjust the attached image quality.
SMTP Setting
Sets the SMTP mail server.
Using the mouse may help make setup easier.
1. In the <Network> setting window, press the up/down
( ) button to move to <Mailing Service> and press the
[ENTER] button.
2. Select <SMTP>.
You will see the SMTP setting window.
3. Use direction buttons ( ◄ ►) to move to a desired item
and set the value.
• ServerType : Displays the connected server type.
• Server : Enter a server to connect to.
• Port : Sets the communication port.
• Use Authentication : Check this if the SMTP server uses user authentication.
The account input box will be activated.
• User : Enter a user to use authentication when connecting to the SMTP server.
• Password : Enter the password of the SMTP server user.
• Secure Transfer : Select one from <Never> and <TLS (if available)>.
• Sender : Use the virtual keyboard to enter the sender's e-mail address.

Refer to "Using Virtual Keyboard". (Page 34)
• TEST : Conducts the test on the server settings.
4. When the SMTP setting is done, press <OK>.

Event Setting

You can set the interval and type of the event that will be sent to the user.
Using the mouse may help make setup easier.
1. In the <Network> setting window, press the up/down
( ) button to move to <Mailing Service> and press the
[ENTER] button.
2. Select <Event>.
3. Use direction buttons ( ◄ ►) to move to a desired item
and set the value.
• Event Interval : Set the event interval.

If a series of events occurs, the e-mail will be sent at the specified
interval, not on each event.
• Use Event Transfer : Select an event type to send if an event
occurs.
If the selected event occurs, the e-mail will be sent to the group that has the recipient authority.
4. When the event setting is done, press <OK>.
60_ using the DVR
Mailing Service
SMTP
Event Group
 ServerType
SMTP mail Server
 Server
 Port
25
Use Authentication
 User
 Password
********
 Secure Transfer
Never
 Sender
TEST
OK Cancel
Mailing Service
Event
SMTP Group
 Event Interval
10 min
Use Event Transfer
Sensor Motion
Change P/W HDD Info
Power On/Off Manual Record
OK Cancel
Recipient
ex. user@example.net
Recipient
Video Loss