Side Shelf/Side Burner Assembly - Frigidaire Gallery Series Use & Care Manual

Side Shelf/Side Burner Assembly

Side Shelf and Side Burner Attachment
1. Loosen the bolts on the side of the grill and
attach the shelf by allowing the bolt heads to
fall through the large opening in the bottom of
the keyhole slots. Then slide the shelves
downward until the bolts are resting against
the top of the key hole slots. Tighten all of
the shelf bolts. (See Fig. 5)
2. Attach the wires coming out from the sides of
the grill to the ignitor terminals. (See Fig. 6)
Note: It does not matter which wire goes to which
terminal on the four wire ignitor
1. Attach the side burner by allowing the bolt
heads to fall through the large opening in the
bottom of the keyhole slots. Then slide the
side burner downward until the bolts are
resting against the top of the key hole slots.
Tighten all of the side burner bolts.
2. Screw the Flex Line coming from the side of
the grill to the fitting on the bottom of the
Side Burner. (See Fig. 7)
3. Attach the ignitor wires coming out from the
side of the grill to ignitor terminals.
(See Fig. 8)
Note: It does not matter which wire goes to which
terminal on the two wire ignitor
4. Install burner into side burner tray lining up
the three cutouts on the underside of the
burner. (See Fig. 9)
5. Install burner cap onto burner (See Fig. 10)
Fig. 10
5
Fig. 5
Fig. 6
Attach to fitting
Fig. 7
Fig. 8
Ignitor
wires
hookup
Fig. 9