Table of Contents
Advertisement
SD Memory Card/SDIO Card/MultiMedia Card
About SD Memory Card/MultiMedia Card
An SD Memory Card/MultiMedia Card can be used for the following purposes.
The exchange of data with various devices equipped with an SD card/MultiMedia Card
slot, audio storage, and so on.
NOTE
Software (e.g., drivers) required to exchange data with these devices. (Refer to the
instructions manual provided with each SD compatible peripheral device.)
Use as a memory card (e.g., use as a storage unit on which files can be written).
About SDIO Card
Before using the SDIO card, the software attached to SDIO card has to be installed. For
details, refer to the instructions manual provided with the SDIO card.
Inserting/Removing a Card
1
Open the SD card*
SD card includes an SD Memory Card and an SDIO card.
1
*
2
Inserting
Slide the card in until it snaps into place as shown in the
illustration.
Make sure the labeled face of the SD card/MultiMedia
Card is towards the front of the computer and then firmly
insert the card. If you mistake the back side of the card
with the top surface side, the card cannot be inserted all
the way into the slot.
Do not insert the card at an angle.
Removing
(1) Press the card. It will come out slightly.
(2) Remove the card.
3
Close the SD card/MultiMedia Card slot cover.
CAUTION
Before removing an SD card/MultiMedia Card or powering off CF-P2, check to see the
SD card LED indicator whether CF-P2 is accessing the card. Such accesses are done
intermittently for a short period of time. Be sure to remove the card or power off CF-P2
only after confirming that CF-P2 is not accessing the card. If the card is removed or CF-P2
is powered off during an access attempt, valuable data may be lost or CF-P2 may fail to
work properly. With the SDIO card, in some cases access is not interrupted, so refer to the
instructions manual provided with the SDIO card.
1
/MultiMedia Card slot cover.
SD card/MultiMedia
Card Slot
31
Advertisement
Table of Contents
