Related Manuals for Cardinal PS-11
Summary of Contents for Cardinal PS-11
- Page 1 MODEL PS-11 DIGITAL PORTION SCALE OWNER’S MANUAL CARDINAL SCALE MFG. CO. PO BOX 151 • WEBB CITY, MO 64870 8528-M310-O1 Rev A PH (417) 673-4631 • FAX (417) 673-5001 04/04 Web Site - http://www.detectoscale.com...
-
Page 3: Table Of Contents
INTRODUCTION TABLE OF CONTENTS Thank you for purchasing our Detecto Model Installation …………………..………………. 1 PS-11 Digital Portion Scale. The PS-11 is Unpacking ……………………..………… 1 equipped with a rechargeable battery pack Power Supply …………………..………. 1 that (after 8 hours of charging) is able to Batteries ………………………..……….. -
Page 5: Installation
It will take approximately 8 hours to fully recharge the battery pack in the scale. While the batteries are charging the PS-11 can still be operated. Note that charging the battery pack for more than 8 hours will not damage it. -
Page 6: Display Annunciators
DISPLAY ANNUNCIATORS The annunciators are turned on to indicate that the scale display is in the mode corresponding to the annunciator label or that the status indicated by the label is active. The O annunciator is turned on when the weight display is stable. The lb annunciator is turned on to indicate that the displayed weight is in pounds. -
Page 7: Operation
OPERATION TURN THE SCALE ON Press the ON/OFF key to turn the scale on. The scale will display then change to the selected weighing units. SELECT THE WEIGHING UNIT Press the UNITS key to alternate between the selected weighing units. NOTE! Multiple weighing units must be enabled during configuration for this function to be operational. -
Page 8: Configuration
CONFIGURATION The Scale has been pre-configured at the factory and should not require configuration for use in most applications. In the event that the factory settings do not meet the requirements of your application, the following describes the steps to configure the scale. TO BEGIN CONFIGURATION: 1. - Page 9 CONFIGURATION, Cont. To select “g” (gram) weighing units: 1. With the display showing (1.< , press the ZERO key and then UNIT key 3 times. The display will change to show “g”. 2. Press ZERO key to display g (gram) status. 3.
-
Page 10: Gravity Compensation
GRAVITY COMPENSATION The Gravity Compensation for your scale has been pre-configured at the factory and should not require changing in most locations. In the event that the factory settings do not meet the requirements of your location, contact the factory for the value for your location. With :=a enable from the function setting of the Configuration mode, the scale will use the factory set value of 9.797 for the Gravity Compensation. -
Page 11: Display Messages
DISPLAY MESSAGES DISPLAY MEANING Low battery indication 5::5a prom Error 5::0a Zero count under 128 AAAAAa Over capacity (upper dashes) BBBBBa Under capacity (lower dashes) :: a Zero count over 65,000 +91 a Calibration span too high Power-on zero count under 77777a calibration zero (-10%) 77777a...