SY-K7VMP2 Quick Start Guide
3
3
Quick BIOS Setup
This motherboard allows you to change your memory and onboard peripheral settings in
BIOS setup. After the hardware installation is complete, turn the power switch on, then press
the <DEL> key during the system diagnostic checks to enter the BIOS Setup program. The
CMOS SETUP UTILITY will be shown on the screen. Then, follow these steps to configure
your system.
Select [STANDARD CMOS SETUP]
Step 1.
Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to "Auto".
Select [LOAD OPTIMIZED DEFAULTS]
Step 2.
Select the "LOAD OPTIMIZED DEFAULTS" menu and type "Y" at the prompt to load the
BIOS optimal setup.
Select [SAVE & EXIT SETUP]
Step 3.
Press <Enter> to save the new configuration to the CMOS memory, and continue the
boot sequence.
18