SOYO SY-K7VMP2 Quick Start Manual page 17

CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps below to
clear the CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. Its
white cap can easily identify this jumper.
2. Put the jumper back to 1-2 to allow writing of new data into the CMOS memory.
CMOS Clearing
Short pin 2-3 for
JP5 Setting at least 5 seconds to
clear the CMOS
Note: You must unplug the ATX power cable from the ATX power connector
when performing the CMOS Clear operation.
On-board Speaker connection
When using 2-channel speaker, connect the speaker cable to Line-out.
If you're using 4 channel speaker, connect the front L/R speakers to Line-out and rear
L/R speakers to Line-in. Make sure that the audio software is set for 4 channel speaker
system.
If you are using 6 channel speaker, connect the front L/R speakers to Line-out and the
rear L/R speakers to Line-in. Connect the Center/Bass to Mic-in.
SY-K7VMP2 Quick Start Guide
Clear CMOS Data
17
Retain CMOS Data
Short pin 1-2 to
retain new settings
Line-in
Line-out
Mic-in