Attach Tool Holder - Hoover SteamVac Widepath User Manual

The assembled cleaner will look like this
drawing (LS model shown).
1-4
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
1-7
Replace clean solution tank (upper tank)
by positioning bottom first. Press on
tank handle to snap top of tank into
place.
4
Assemble handle
1-2
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
1-5
B
Place nuts in recessed areas on back of
handle. Hold each nut in place while
tightening each bolt securely (from the
front of the handle) with a Phillips screw
driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
1-8
Press cord into cord clip on back of
handle. Pull cord tight.
1-3
With cord hook (A) to back of deep cleaner,
push upper handle down onto lower han-
dle. Push b o l t s into holes on f ront of han-
d l e. If bolts will not go through hole easi-
ly handle is not pushed completely
d ow n .
1-6
D
When handle sections are completely
together, squeeze trigger (C) and
depress Clean Surge™ Button (D) on
upper handle to snap trigger rod in
place.
1 - 9

Attach tool holder

Remove tool and taped screw from holder.
Insert projections on holder into slots on
back of cleaner.
A
C