The assembled cleaner will look like this
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
Replace clean solution tank (upper
tank) by positioning bottom first.
Press on tank handle to snap top of tank
Attach upper handle
Remove clean solution tank (upper
tank) from deep cleaner.
Place nuts in recessed areas on
back of handle. Hold each nut in
place while tightening each bolt securely
(from the front of the handle) with a
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
Press cord into cord clip on back of
handle. Pull cord tight.
With cord hook (A) to back of deep
c l e a n e r, push upper handle down onto
lower handle. Push b o l t s into holes on
f ront of handle. If bolts will not go
t h rough hole easily handle is not pushed
c o m p l e t e ly dow n .
When handle sections are com-
pletely together, squeeze trigger (C)
on upper handle to snap trigger rod In
Attach tool holder
Remove tool and taped screw from
Insert projections on rack into slots on
back of cleaner.