Kettler Favorit Assembly Instructions Manual page 15

Step 3
Resistance Adjustment Example - Picture "C" shows the clamp positioned ¾ of the
way up on the fifty knurl marks, 13 knurl marks above the clamp can be
seen. There is a group of ten knurl marks, then a wider gap and then three more
knurl marks above the clamp. The arrow shows the clamp positioned at level 37 of
50.
Step 4
To adjust resistance, it is best & easiest to first pull the rower arm back to a 90˚
angle. Loosen the clamp, then slide the clamp to the desired resistance level and
retighten, picture "D". Mirror this step for the other rower arm, making sure the knurl
marks are set at the same resistance level.
Step 5
There are five sets of ten knurl marks each with a wider gap between then next set
of ten. The arrow in picture "E" is pointing at the 1 knurl mark. The clamp is below
st
all 50 knurl marks and thus at the lowest level of resistance. Note: At this position,
the resistance level amount is less than 10lbs.