Table of Contents
Advertisement
7 7
Appliance Preparation
A. Removing Non-combustible Facing Mate-
rial Assembly
The non-combustible assembly is located on the back
side of appliance.
CAUTION
Handle with care
• Non-combustible material may be damaged if dropped.
• Hold non-combustible pieces in place.
• Remove and save two screws from upper bracket.
• Remove non-combustible pieces.
• Remove and save three screws from lower bracket.
• Discard brackets.
• Replace screws in holes where brackets were attached
to appliance.
B. Installing the Optional Heat-Zone-Gas Kit
Before installing fi nishing materials, use these instructions to
attach the Heat-Zone-Gas kit to the top of the QV36A-FB.
CAUTION
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
1. Remove the four screws that attach the Heat Zone
Cover Plate to the top of the appliance.
REMOVE SCREWS
Figure 7.1. Remove Screws.
2. Bend the four pre-cut tabs up to expose the top of the
appliance. Place the Heat Zone cover plate on the
insulation inside the unit centered between the three
pre-cut tabs that are the same size as shown in Figure
7.2. Use the Heat Zone cover plate as a template and
cut around it carefully with a utility knife.
20
Quadra-Fire • Expression 36 (QV36A-FB) • 2062-900 Rev. Q • 2/10
BEND TABS UP
Figure 7.2. Bend Tabs and Cut Insulation.
3. Discard the Heat Zone cover plate and insulation
piece that was cut out. See Figure 7.3. With a self-
tapping screw or drill bit, drill out the three holes on the
cover plate of the appliance. This will make it easier to
mount the Heat-Zone-Gas collar.
COVER PLATE HOLES
Figure 7.3.
4. Remove the four screws securing the cover plate to
the inside of the appliance and discard them along
with the cover plate. See Figure 7.4.
Figure 7.4.
CUT LINE
Advertisement
Table of Contents
