Fixing The Oven - DeLonghi MULTIFUNCTION BUILT-IN OVENS WITH SIDE OPENING DOOR Installation And Service Instructions Use And Care Instructions

FIXING THE OVEN

Introduce the oven into the furniture opening and fix it with screws (not supplied)
as figure 9. It is essential that the oven rests on a surface which will support its
weight, as the screw fixing is only complementary.
Note: It is essential that when installing
your oven adequate air circulation is
allowed for within the installation. See fig-
ures 6 - 8.
Inadequate air circulation may greatly
impair the performance of your oven
and may effect adjacent cabinets due
to an increase in temperature.
Caution: Do not lift this oven by
the door handle.
Adjust the hinges of furniture doors
adjacent to the oven to allow a 4-5 mm
gap between the furniture door and
the oven frame.
IMPORTANT:
To avoid damage to the lower trim please note the following instructions.
The lower trim is designed to allow for good air circulation and the correct opening
of the oven door.
To ensure the trim is not damaged due to the appliance being placed on the floor,
the appliance should be suitably supported as in above illustrations.
After installation the appliance door should be slowly opened to ensure no damage
has occurred.
No responsibility for lower trim damage will be accepted if these instruc-
tions have not been followed.
AIR FLOW
10
Figure 10
OVEN DOOR
LOWER TRIM
Figure 9