Alarm Logs - Black Box Series 5000 Reference Manual

Event Logs

Alarm Logs:

* Auto-learning of LMI type on link X unsuccessful
Generated when the LMI type on a link is not successfully auto-learned.
* Backup Battery is bad
The backup battery power for memory backup has dropped below operating level, replace the batteries (see
Installation and Applications Manual, Appendix D.
* Bad internal block checksum detected
Generated when power up diagnostics finds a fault in the internal block of the EEPROM.
* Call X connected
Generated when an ISDN call has completed connection and is ready to start B channel communication.
* Closing remote site X (call limit)
Generated when the specified number of calls has been exceeded.
* Closing remote site X (callback failure)
Generated when the remote site interpreted the call sequence as a callback. However, a callback was not
completed in the expected time frame.
* Closing remote site X (frame relay closing)
Generated due to the frame relay protocol being disabled on the bridge/router.
* Closing remote site X (force disconnect)
Generated when the connection to a remote site is being closed due to a force disconnect.
* Closing remote site X (inactivity)
Generated when the connection to a remote site is being closed due to an inactivity timeout.
* Closing remote site X (IP triggered RIP)
Generated when the connection to a remote site is being closed due to failure of IP triggered RIP.
* Closing remote site X (IPX demand RIP)
Generated due to the failure of IPX demand RIP.
* Closing remote site X (last session)
Generated due to the termination of the last session.
* Closing remote site X (link disabled)
Generated due to the link being disabled by the operator.
52