The Basics Of Metal Detecting - Bounty Hunter Lone star Pro Owner's Manual

TARGET IDENTIFICATION
Target-ID
This is a motion detector. When objects are detected, the detector will emit a
sound. A segment will illuminate along the Target Conductivity Arc. The
illuminated segment indicates the Target-ID of the last object detected.
This detector has fast target response and is able to detect different objects in
very close proximity. Therefore, the Target-ID displayed may change rapidly as
you sweep the searchcoil.
Three seconds after the last Target-ID is displayed, the Target-ID will time-out
and the segment will disappear.
3-Tone Target Identification
The detector will provide 1 of 3 sounds for any metal object detected: a low,
medium or high tone. This audio feedback system is useful in conjunction with
the visual Target-ID system described above.
LOW MEDIUM
TONES TONES
The faceplate label is color-coded above the Conductivity Arc. Ferrous, gold and silver
targets will generally register within their corresponding color-coded ranges. Targets that
are not gold or silver register within the same range according to their electrical
conductivity.
Note that the electrical conductivity of a target depends on both its composition and size.
Silver is more conductive than gold so it registers farther to the right; and the larger the
silver object, the farther it registers to the right.
12
HIGH
TONES

THE BASICS OF METAL DETECTING

5. EMI (Electromagnetic Interference)
The searchcoil produces a magnetic field and then detects changes in that
magnetic field caused by the presence of metal objects. This magnetic
field that the detector creates is also susceptible to the electromagnetic
energy produced by other electronic devices. Cell phones, cell phone
towers, power lines, microwave ovens, lighting fixtures, TVs, computers,
motors, etc... all produce EMI which can interfere with the detector and
cause it to beep when no metal is present, and sometimes to beep
erratically.
The SENSITIVITY control lets you reduce the strength of this magnetic
field, and therefore lessen its susceptibility to EMI. You may want to
operate at maximum strength, but the presence of EMI may make this
impossible, so if you experience erratic behavior or "false" signals, reduce
the sensitivity.
USING THE DETECTOR
Sweep Method
Sweep the detector side-to-side over
the ground.
Keep the searchcoil parallel to the
ground as you sweep; do not lift the
searchcoil at the ends of your sweeps.
Searchcoil motion is required for target
detection.
8" WATERPROOF SEARCHCOIL
This detector is equipped with an 8" diameter concentric waterproof searchcoil.
This lightweight, ruggedly constructed searchcoil can be fully submerged into
water. The bottom portion of the S-Rod can also be submerged, but the control
housing and the searchcoil cable plug connection into the housing must be
kept dry.
Accessory searchcoils are also available for purchase; see back cover or visit
www.detecting.com. A smaller searchcoil offers more precision and fits into
tight spaces. Larger searchcoils provide for more ground coverage on each
sweep and penetrate deeper into the ground. Biaxial searchcoils better
penetrate mineralized soils.
CORRECT
WRONG
9