Batteries (Use Alkaline Batteries Only); Headphone Jack; Using Headphones - Bounty Hunter Lone star Pro Owner's Manual

BATTERIES
The detector requires a single 9-volt ALKALINE battery (battery not included).
Do not use ordinary "Zinc Carbon" batteries
Do not use "Heavy Duty" batteries.
Rechargeable batteries can also be used. If you use rechargeables, we
recommend using a "Nickel Metal Hydride" rechargeable battery.
The battery compartment is located on the back side of the Control Housing.
Slide the battery door to the side to remove. Insert battery. Close battery door.
When it's time to replace the battery simply push down firmly on the bottom of
the battery (see illustration).
BATTERY LIFE
Expect 20 to 25 hours of life from a
9-volt alkaline battery.
Rechargeable batteries provide about 8
hours of usage per charge.
BATTERY INDICATOR
The battery icon has three segments
plus an outline segment.
The amount of battery voltage for an
ALKALINE battery is indicated as
follows:
3 segments illuminated:
2 segments illuminated:
1 segment illuminated:
No segments illuminated: 6.2 to 6.4 volts
Outline Flashing:
SPEAKER VOLUME AND BATTERY CHARGE
You may notice the speaker volume drop while one battery segment is
illuminated.
With the outline flashing, low speaker volume will be very apparent.
6
Patent Pending
BATTERY
REMOVAL
8.1 volts or more
7.1 to 8.0 volts
6.5 to 7.0 volts
6.1 or less
CONTROLS
Press to program the NOTCH feature. Each press of
cycles to a new category and that category icon will flash
for 2 seconds. Then the category will reverse status. If the icon
had previously been illuminated it will now disappear indicating
that the category has been eliminated from detection. Likewise,
an icon that is not visible on the display will re-illuminate,
indicating that this category is now "Notched in" (i.e. detected).
Use to select the category to NOTCH. Each time you
press the category for metal to be notched flashes on the
screen. Any of the 4 categories can be "Notched" in or out. After
the category icon flashes and times out, the Notch status will
change.

HEADPHONE JACK

This detector has a 1/4" headphone
jack. It works with any stereo
headphone that has a 1/4" plug.
When the headphone jack
connected, speaker volume
disabled.

USING HEADPHONES

Using a detector with headphones
facilitates detection of the weakest
signals and also extends battery life.
It also allows you to hear subtle
changes in the sound more clearly,
particularly if searching in a noisy
location. For safety reasons, do not use headphones near traffic or where other
dangers are present. This device is to be used with interconnecting
cables/headphone cables shorter than three meters.
is
is
15