Adjusting The Cutting Height; How To Use - Flymo Hover Vac Original Instructions Manual

J
K
L
1
2
M
1
2
N

Adjusting the Cutting Height

HIGHEST
This symbol visible
LOWEST
This symbol visible
3
3

How to Use

THERE ARE 2 CUTTING HEIGHTS (J & K)
• Height of cut is adjusted by turning over the
cutting head.
• Disconnect from the mains electricity supply and
wait until the cutting head has stopped rotating.
Turn your product upside down.
• To Remove the Cutting Head and Fan (L)
Hold the fan firmly and twist the cutting head
anti-clockwise as illustrated. Hold the cutting head
in the centre and remove as illustrated. Hold fan in
the centre and remove as illustrated.
• Inspect for damage and clean as necessary before
replacing the fan and the cutting head.
• To Refit the Fan and the Cutting Head (M)
Replace the fan as illustrated. Replace the cutting
head, adjusting the height of cut as required. Hold
the fan firmly and twist the cutting head clockwise,
as illustrated.
• IMPORTANT
ENSURE FAN AND CUTTING HEAD ARE
CORRECTLY LOCATED
1. Start at the edge of the lawn nearest to the power
point so the cable is laid out on the lawn you have
already cut. (N)
2. Cut your grass twice a week during the growing
season, your lawn will suffer if more than a third of
its length is cut at one time.
Do Not Overload Your Product
Using in long thick grass may cause the motor speed to
drop, you will hear a change in the motor sound. If the
motor speed drops you may overload your product
which may cause damage. When using in long thick
grass a first cut with the cutting height set higher will
help reduce the load. See Adjusting the Cutting Height.