Adjusting The Cutting Height - Flymo TURBO LITE User Instructions

L
blade bolt
1. To remove the blade bolt, hold the fan firmly and with
the spanner provided loosen the blade bolt by turn-
ing it anti-clockwise (M).
2. Remove the blade bolt, blade, spacers and fan.
3. Inspect for damage and clean as necessary.
• Renew your metal blade after 50 hours mowing or 2
years whichever is the sooner - regardless of condi-
tion.
• If the blade is cracked or damaged replace it with a
new one.
• Never use a blade bolt if the insulated head is dam-
aged cracked or missing.
1. Ensure the fan is located correctly.
2. Place the spacers onto the fan ensuring the pegs
have located into the holes.
3. Place the blade onto the spacers ensuring the pegs
have located into the holes on the blade and ensur-
ing the blade is positioned as illustrated in Figure N.
4. Place the blade bolt through the centre hole of the
blade.(N)
5. Tighten down clockwise by hand.
6. Hold the fan firmly and tighten the blade bolt with the
spanner provided.

Adjusting the Cutting Height

blade
cutting
height
spacers
fan
Removing the Blade and Fan
Fitting the Blade and Fan
Always handle the blade with care - sharp edges could
cause injury. USE GLOVES. Never use more than 3 Cut-
ting Height Spacers for the Turbo Lite 330 OR 4 Cutting
Height Spacers for the Turbo Lite 350/400. Spacers must
only be fitted between the blade and the fan and NEVER
between the blade and the bolt.
1. Remove the blade bolt, and blade as described in
Removing the Blade and Fan.
2. For a Lower Cut - Add spacers to a maximum of 3 for
Turbo Lite 330, or 4 for Turbo Lite 350/400.(L)
3. For a Higher Cut - Take spacers away.
4. Refit the blade as described in Fitting the Blade and
Fan.
M
N
Turbo Lite 330 Turbo Lite 350/400