Table of Contents
Advertisement
BT 10e
24. The only means of completely disconnecting the product from the power supply is by
removing the power cord from the wall outlet or the product. The wall outlet or the power
cord entry to the product must remain freely accessible at all times while the product is in
use.
25. Try to install the product near a wall socket or extension cord and shall be easily
accessible.
26. The highest environmental temperature suitable for this product is 35°C.
27. ESD hints - If the product maybe reset or not reset to operation of control due to
electrostatic discharge, just switch off and reconnect again,
another location.
28. Battery
1).The batteries must not be exposed to excessive heat such as sunshine, fire or the like.
2).The batteries should be drawn to the environmental aspects of battery disposal.
3).Battery usage CAUTION-to prevent battery leakage which may result in body injuries,
property damage, or damage to the apparatus:
- Install all batteries correctly, + and – as marked on the apparatus.
- Do not mix batteries (old and new or carbon and alkaline, etc.)
- Remove batteries when the unit is not used for a long time.
ERP2 - (Energy related products) note
This product complies with the European Commission on Ecodesign Directive and its
implementing Regulations Energy related products because the unit works with low
voltage and current external power supplier. You can reference the regulation on EC No.
1275/2008 for details.
Warning
This appliance is not intended for use by persons (including children) with reduced
physical sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play
with the appliance.
1.Never use the device unsupervised! Switch off the device whenever you are not using it,
even if this only for a short while.
2.The appliance is not intended to be operated by means of an external timer or separate
remote control system.
3.If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
4.Before operating this system, check the voltage of this system to see if it is identical to
the voltage of your local power supply.
5.The unit should not be impeded by covering the ventilation opening with items such as
newspaper, table-cloths, curtains etc. Make sure that there are at least 20 cm of space
above and at least 5 cm of space on each side of the unit.
6.The apparatus must not be exposed to dripping or splashing and that objects filled with
liquids, such as vases, must not be placed on the apparatus.
25
or move the product to
Advertisement
Table of Contents
