Oregon 511A Instruction Manual page 10

8
Figure 11
C. Dressing The Grinding Wheel:
1. Set the motor/head to the 90-degree position.
2. With the grinder in the "OFF" position.
Check the profile of the wheel using the spe-
cial template (provided with this unit). If the
wheel profile is not correct according to the
template, the wheel will need to be dressed
until it does fit the proper profile.
3.Connect the plug correctly to a serviceable
electrical outlet, then turn the grinder to the
"ON" position.
4. From a safe distance at the side of the unit,
observe the grinding wheel as it turns to
make sure it does not oscillate either laterally
or transversally. If wheel turns in a true and
even rotation, allow wheel to turn for one
minute before wheel is dressed.
Note: If the wheel does not run true, turn
the unit off, troubleshoot and correct the
problem before proceeding.
A S S E M B L Y I N S T R U C T I O N S
5. Begin dressing the full radius of the wheel
6. Turn the unit off and use the special orange
Figure 12
with the use of the dressing brick provided
with this unit #9 (see Figure 11). For best
results use quick, light strokes with the brick
to form the desired profile (see Figure 11).
template #10 to re-check the profile of the
wheel (see Figure 12). Note: If necessary,
turn electrical power on and repeat steps 5
and 6 until desired profile of the wheel is
obtained.
Note: For 511A-BC use template for 3/4"
pitch wheel included #17.
Replace the wheel if necessary.