Table of Contents
Advertisement
Preparation
Clean the housing main o-ring and retest to make sure that it is
watertight. Refer to the Troubleshooting section, page 18.
Please read your camera manual thoroughly to have a full
understanding of each camera function.
If you are new to underwater photography, be sure to read the Photo
Tips section, page 17.
Initial Camera Setup
-
Insert a fully charged camera battery.
-
Set Mode Dial to "Av" Aperture Priority and ISO to "200."
-
Raise Flash and set to "Flash always fires
In
MENU:
-
Push
button and move to the center. Set Digital Zoom to "Off."
Set AF-Point Zoom to "Off" and Set Servo AF to "On."
Set Continuous AF to "Off" and AF-assist Beam to "Off."
Set MF-Point Zoom to "2X" and Safety MF to "On."
In the Flash Control Built-in Flash Settings Menu, set Red-eye Corr.
and Red-eye Lamp to "Off."
Set Review Image after Shooting to "4 sec." and Display Info to "Off."
Set Blink Detection to "Off" and IS Settings Mode to "Continuous."
Set Spot AE Point to "Center" and Safety Shift to "Off."
Set Shortcut Button to
-
In
MENU:
Set Date/Time and Time Zone.
Set Lens retract to "1 min" and Eco Mode to "Off."
In the Power Saving Menu, set Auto Power Down to "Off" and Display
Off to "3 min."
Insert and Format an SDHC memory card.
-
In FUNC./SET MENU:
Set DR Correction to "Off" and AWB White Balance to "Auto."
4
- continued
(before placing camera in housing)
Custom White Balance or desired setting.
."
Advertisement
Table of Contents
