Table of Contents
Advertisement
Initial Camera Setup
Set White Balance to "AWB." For best results, use manual
White Balance and reset for each working depth.
Set Drive Mode to "Single Shot
Set Metering to "Center Weighted Avg.
Set ND Filter to "Off" and Still Image Aspect Ratio to "4:3."
Set Image Type to "JPEG 12M" and Image Compression to "L."
Set Image Quality to "Superfine" and Movies to "FHD/60P."
-
Set Macro mode
is overexposed, use "-" Flash Exposure Compensation
and/or back away, zoom in, and then reshoot.
Note: TTL Flash is NOT available when camera is in "M" Manual mode. See
your Canon camera manual for further information.
Parts of the Housing - Front View
Attach fiber optic cords to the housing Fiber Optic Ports, to fire compatible
external strobes. The Factory installed Flash Deflector, page 10, will reduce
backscatter and assist in redirecting the flash to the Fiber Optic Ports. Remove the
Deflector when using ONLY the camera flash.
Shutter
Button
Lid Snap
External Tray Mount
-
continued
to "On" when shooting close-up. If the image
Zoom
Lever
."
"
Mode Dial
Lens Port
Custom
Fiber Optic Ports
5
Advertisement
Table of Contents
