WEISS Vesta Owner's Manual page 19

OWNERS MANUAL FOR WEISS VESTA FIREWIRE INTERFACE
Input Source Connection, Selection and Synchronization
Connect sources with sampling frequencies of 44.1, 48, 88.2, 96, 176.4 or 192kHz to the input
connectors at the back of the unit.
The input source pushbuttons correspond to the inputs as follows:
Firewire: Selects the Firewire input, connected to a computer. Either one of the two Firewire
-
connectors can be used.
AES/EBU: Selects the XLR input.
-
S/PDIF: Selects both RCA and Toslink inputs. At the first hit of the S/PDIF switch the VESTA
-
selects the RCA input. If there is no signal recognized at the RCA input it automatically
selects the Toslink input. If you press the S/PDIF selection switch twice you can skip the
RCA input and select the Toslink input right away.
If a valid Firewire, AES/EBU or S/PDIF signal is present at the selected input, the blue LED stays lit.
If the format and/or the sampling frequency is not valid, the blue LED is flashing. The VESTA
automatically synchronizes to the incoming signal.
The states of all buttons are stored in non-volatile memory, i.e. the actual input selection is
retained when powering the unit off or when disconnecting the unit from the mains completely .
Output Connection
Connect your D/A Converter or digital pre-amplifier to the output connectors of the VESTA. Use
either the XLR or the RCA outputs. It is also allowed to use both outputs simultanously.
19
Page: Date: 10/08 /dw