Swing Operation; Cleaning And Care - Fujitsu ASBA09JGC Operatiing Manual

SWING OPERATION

Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 6 S).
The SWING Display (Fig. 7 ]) will light.
In this mode, the Air Flow Direction Louvers will swing automatically to direct the air fl ow
both up and down.
To stop SWING Operation
Press the SWING button (Fig. 6 S) once again.
The SWING Display (Fig. 7 ]) will go out.
Airfl ow direction will return to the setting before swing was begun.
About Swing Operation
● The SWING operation may stop temporarily when the air conditioner's fan is not operating,
or when operating at very low speeds.
● The range of swing is relative to the currently set airfl ow direction.
During Cooling/Dry mode
During Fan mode

CLEANING AND CARE

CAUTION!
● To avoid excessive wear of the part and components or malfunctioning of the air conditioning, the user/consumer shall perform
preventive maintenance through an accredited technical assistance, periodically. To know the preventive maintenance periodicity,
the consumer shall check with the accredited installer or an accredited technical assistance.
● When used for extended periods, the unit may accumulate dirt inside, reducing its performance. We recommend that the unit be
inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service personnel.
● It is recommended for the user/consumer to demand a copy of the Work Order every time there is a visit of a technical assistance
for verifi cation, maintenance, test or repair of the product.
● When cleaning the unit's body, do not use water hotter than 40 °C, harsh abrasive cleansers, or volatile agents like benzene or
thinner.
● Do not expose the unit body to liquid insecticides or hairsprays.
● When shutting down the unit for one month or more, fi rst allow the fan mode to operate continuously for about one-half day to
allow internal parts to dry thoroughly.
: Swings between 1 and 3.
: Swings between 1 and 3 or 3 and 6.
● Before cleaning the indoor unit, be sure to turn it off and disconnect the Power Supply Cord.
● Be sure the Intake Grille (Fig. 1 8) is installed securely.
● When removing or replacing the air fi lters, be sure not to touch the heat exchanger, as personal injury
may result.
En-10