Table of Contents
Advertisement
Mounting your Extractor
The extractor can be mounted in two ways:
To fasten the product to the underside of a bridging cabinet:
1. Remove the grease filter cover.
2. Screw the hood directly to the cabinet using appropriate wood screws (these
are not supplied).
3. Replace the grease filter cover.
To mount the hood on to a wall:
1. Remove the grease filter cover.
2. Drill four holes as shown as B and Z in figure 4.
Please note:
•
The size required for the hole is dependent on the wall fixings to be used.
3. Insert wall fixings into all four holes.
4. Tighten the fixing screws B, leaving approximately 3 mm proud of the wall.
5. Hang the hood on the fixing screws B and tighten fixing screws Z to secure
into position.
6. Replace the grease filter cover.
Fig. 4
9
Advertisement
Table of Contents
