Download Print this page

Rear Wheel Brakes; Adjusting The Leg Support - Joovy Groove 0080X Instruction Manual

Joovy groove 0080x stroller instruction manual
Hide thumbs Also See for Groove 0080X:

Advertisement

4 Front Wheel Locks
The front wheels can be set to swivel or lock.
• To lock the front wheels, push down on the locking lever located between the wheels until a click is heard. See Figure 4.1. Rotate the wheel
set until it locks automatically in the straight position.
• To unlock the wheels (swivel mode) pull up on the lever.
5 Operating the Canopy
• Insert BOTH plastic canopy clips into the canopy slots on the underside of the stroller frame. Ensure that the clips are secure.
See Figure 5.1.
• Secure the Velcro® tabs at the top of the canopy to the handle tubes. See Figure 5.2.
• The canopy can be adjusted forward and back, and locked open using the canopy locks on BOTH sides. See Figure 5.3.
NOTE: The top rear portion of the canopy has a roll back window. To open, pull the forward edge up, roll the flap back and secure it using
the Velcro® tabs.
• To close the canopy, unlock the sides, then collapse. See Figure 5.4.
• To remove the canopy, unfasten the Velcro® tabs from the handle tubes. While pushing in on the release button, pull the canopy clips away
from the canopy slots on the underside of the stroller frame. See Figure 5.5.
Possible pinching hazard - Be careful of the side hinges when opening and closing the canopy.

6 Rear Wheel Brakes

• Always engage rear brakes before placing child in or removing a child from the stroller.
• To engage the brakes, push down on both of the brake levers until the brake snaps in place. See Figure 6.1.
• Check that BOTH wheel brakes are properly engaged.
• To release the brakes, lift up on the brake lever. See Figure 6.2.
Always make sure the wheel brakes are engaged when the stroller is not being pushed so that the stroller will not roll away.
Never leave stroller unattended, especially on a hill or incline, as the stroller may tip over or slide.
7 Seat Recline Positioning
The seat can be adjusted to any position from upright to reclining. The upright to semi recline positions are for children 6 months and older.
The fully recline position is for children 3 months and older.
• Locate the recline mechanism near the backside of the seat.
• To recline the seat, grasp the recline mechanism, press the top release button, and gently pull toward the rear of the stroller until the seat is
in the desired position. See Figure 7.1.
• If seat is fully reclined, secure the Velcro® on BOTH sides of the seat to the Velcro® on the inside of the canopy's apron. See Figure 7.2.
• To adjust the seat to a more upright position, first detach the apron from the seat if it is attached. Then pull the strap at the end of the recline
mechanism upward while pushing the mechanism forward until the seat is in the desired position. See Figure 7.3. If the canopy's apron is
attached, detach the apron from the seat.
NOTE: To get the seat in it most upright position you may need to push the seat toward the front of the stroller before pulling the straps.
ALWAYS ensure that the seat back is secured into position before placing a child in the seat. Push down on the seat back to be sure it is

8 Adjusting the Leg Support

The leg support can be adjusted fully up or down.
• To place the leg support into the up (horizontal) position, pull up on BOTH sides of the leg support until it is locked into position. Ensure
BOTH sides are locked into place. See Figure 8.1.
• To place the leg support into the down position, locate the trigger mechanism underneath BOTH sides of the leg support. Pull BOTH triggers
and rotate the leg support down. See Figure 8.2.
NEVER allow a child to step onto or sit on the leg support. This may cause the stroller to tip over and injure the child.
EN
WARNING
!
WARNING
!
WARNING
!
secure. NEVER adjust the seat back when the child is in the seat.
WARNING
!
EN

Advertisement

loading