Advertisement
EN
9 Securing the Child
• There are three height adjustment positions for the shoulder harness straps. Adjust the shoulder straps to the closest height of your child's
shoulders by threading the end of the shoulder harness through the seat.
• Ensure that BOTH shoulder straps are attached to the waist strap buckles. See Figure 9.1.
• Unlatch both sides of the waist buckle by squeezing the latch releases.
• Place the child in the seat with the shoulder straps over their shoulders and the crotch strap between the child's legs.
• Attach the waist belt to the harness. See Figure 9.2. Tighten the waist/crotch/shoulder belts to be snug around the child's waist/crotch/
shoulders.
• Both the shoulder straps and the waist/crotch straps may be adjusted using the sliding buckles on these straps. See Figures 9.3 and 9.4.
NOTE: To reinstall the 5 point harness, first attach the shoulder straps at the correct height position by pushing the plastic ends through the
slots in the seat back. Next, attach the crotch strap to the seat bottom by pushing the plastic end through the slot in the seat bottom. Finally,
attach the waist straps by pushing metal ring ends through the slots on the lower seat back and then attaching the rings to the lower seat
back frame. See figures 9.5 and 9.6.
10 Storage Basket
The maximum weight that can be carried in the storage basket is 2.27 kg
11 Folding the Stroller
• Keep children away from stroller while folding.
• Close the canopy.
• Put seat into the most upright position.
• Make sure both rear wheel brakes are set to their locked positions.
• Lock BOTH front wheel sets in place with locking levers facing forward.
• To fold, pull UP on the primary locking handle in the rear center of the stroller. See Figure 11.1. Then push down on the secondary locking
lever on the right side of the stroller and push the handle fully forward. See Figure 11.2.
• The locking latch on the right side of the stroller should automatically engage. If it is not engaged, gently push the stroller together until the
lock catches the extended rivet. See Figure 11.3.
CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
12 Installing the Rain Cover
• The canopy on the stroller should be in an open position, but with the visor closed.
• Place the rain cover over the stroller with the top (double seam) of the rain cover over the front edge of the canopy.
• Attach the top Velcro® straps on BOTH sides of the rain cover to the side frame tubes.
• Attach the bottom Velcro® straps on BOTH sides of the rain cover to the legs of the stroller.
For use ONLY on the Joovy Groove Stroller. Never leave this cover in place with child in stroller when exposed to direct sun or high
temperature, as temperature inside may be excessive. This product is not a toy. DO NOT allow children to play with it.
Maintenance
Inspect all of the parts of the stroller periodically to ensure that they are secured, not torn or damaged and functioning properly. Any missing,
broken, or worn components should be replaced immediately, and the stroller should not be used until they are replaced. Only original
manufacturer's components should be used. If needed, please contact Joovy.
Cleaning
The fabric material on this stroller can be cleaned using mild household soap or detergent and warm water on a sponge or clean cloth. Always
allow the fabric to completely air dry before using the stroller.
The frame and wheels should always be kept clean and free of dirt and foreign matter, especially after operating the stroller in rain, snow, or
other harsh environments. Use a sponge or cloth dampened with warm water and a mild household soap or detergent to clean the wheels
after such use.
WARNING
!
Avoid serious injury from falling or sliding out. Always use the safety harness.
WARNING
!
ALWAYS keep children away from the stroller when folding.
WARNING
!
.
Groove Instruction Manual
Advertisement
