Related Manuals for Miller Rapidlock SOLO 100
Summary of Contents for Miller Rapidlock SOLO 100
- Page 1 Tr i p o d S e r i e s OPERATOR’S MANUAL #1630 - Solo 75 2-Stage Tripod (Alloy) #1501 - Solo 75 2-Stage Tripod #2001 - Solo 75 3-Stage Tripod #1505 - Solo 100 3-Stage Tripod...
-
Page 2: Features And Controls
Features and Controls 75mm Bowl or 100mm Bowl Leg Angle Adjuster Leg Mounting Bolt Shoulder Strap Mounting Point Protective Leg Cover Leg Lock Direction Label (also leg strap mounting point) Upper Concentric RAPID LOCK Middle Concentric RAPID LOCK Lower Concentric RAPID LOCK Screw Down Rubber Foot Steel Spike... -
Page 3: Technical Data
Introduction Operation Manual Thank you for purchasing the Miller SOLO RAPID LOCK tripod. The operating instructions are described in five steps. Please read and understand SOLO RAPID LOCK is a professional tripod, compatible with industry these instructions before using this standard 75 &... -
Page 4: Tripod Setup
Fig 3 Leg angle adjuster Tripod Setup raised Remove tripod from carry bag, undo clip on leg strap and Minimum Height stand on a level surface (if possible). Depending on Fig 1 Collapsed surface, screw out rubber foot for non-scratch contact Note: It is recommended that position to interior or hard surfaces or screw in for a spike on... - Page 5 Tripod Setup (cont) Tripod Pull Down Mid Position 1 Remove camera from fluid head. Fig 5 Leg angle adjuster 2 Close the tripod legs so all are pointing Note: This refers to the mid leg raised straight down and disengage all angle position, not necessarily the concentric locks.
-
Page 6: Shoulder Strap
Shoulder Strap Leg Pivot Adjustment SOLO’s Shoulder Carry Strap can be used looped (both The leg to bowl pivot joint on the SOLO RAPID LOCK tripod should have ends attached to the mounting point on the bowl), to carry no lateral movement and should swing with a firm, smooth resistance. the tripod on one shoulder, As this is a spreader-less tripod, the leg pivot joint requires sufficient resistance to hold the tripod legs together while being hand carried. -
Page 7: Maintenance
Regularly clean tripod with a damp rag or soft brush. Wipe off all sand, dust and salt spray. Do not clean with solvents, cleaning fluids, lubricants, polishes, abrasives or wire brushes. Transport and store tripod in Miller bag or case wherever possible. Store tripod in a dry place, away from direct sunlight. - Page 8 Miller Authorised Service Agents must carry out all service and repair Cat# Description work on SOLO RAPID LOCK tripods. Failure to observe this requirement may void warranty. It is advisable to notify Miller or a Miller Authorised #394 Solo Dolly #P6005 17mm Spanner...
Need help?
Do you have a question about the Rapidlock SOLO 100 and is the answer not in the manual?
Questions and answers