Assembling The Detector - Bounty Hunter Quick Draw Pro Owner's Manual

USING THE DETECTOR
Sweep Method
Sweep the detector side-to-side over
the ground.
Keep the searchcoil parallel to the
ground as you sweep; do not lift the
searchcoil at the ends of your sweeps.
Searchcoil motion is required for target
detection (except when using Pinpoint).
HEADPHONE JACK
This detector has a 1/4" headphone
jack. It works with any stereo
headphone that has a 1/4" plug.
When the headphone jack
connected, speaker volume
disabled.
USING HEADPHONES
Using a detector with headphones
facilitates detection of the weakest
signals and also extends battery life.
It also allows you to hear subtle
changes in the sound more clearly,
particularly if searching in a noisy
location. For safety reasons, do not
use headphones near traffic or where other dangers are present. This device
is to be used with interconnecting cables/headphone cables shorter than three
meters.
16
CORRECT
WRONG
is
is

ASSEMBLING THE DETECTOR

G
1 Hold S-ROD upright.
G
2 Loosen LOCKING COLLAR on S-ROD;
rotate counterclockwise.
G
3 Insert LOWER STEM into S-ROD with the
SILVER BUTTON pointed upward.
G
4 Rotate the LOWER STEM until the
SILVER BUTTON locates and clicks into
a hole.
LOCKING
COLLAR
INTERNAL
CAM LOCK
SILVER BUTTON
LOWER
S-ROD
LOWER STEM
S-ROD
G
5 Attach the SEARCHCOIL to the LOWER
STEM using the BOLT and KNURLED
KNOB.
G
6 Adjust the LOWER STEM to a length that
lets you maintain a comfortable upright
posture while holding the detector relaxed
at your side with the SEARCHCOIL
parallel to the ground in front of you.
G
7 Wind the CABLE around the STEM.
Leave slack in the cable at the bottom to
allow the searchcoil to pivot.
G
8 Align the pins on the CABLE PLUG to the
connector holes on the rear of the control
housing.
G
9 Push in CABLE PLUG.
G
1 0 Twist the LOCKING COLLAR fully in the
clockwise direction until stems are locked
securely together.
STEM
5