Setting The Am Tuning Step; Switching The Warning Tone; Switching The Auxiliary Setting; Switching The Dimmer Setting - Pioneer DVH-P5850MP Operation Manual

Section
14 Initial Settings
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.

Setting the AM tuning step

The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
 1 602 kHz allowable) to 10 kHz (530  1 640
kHz allowable).
1 Press F to select AM.
Press F repeatedly until AM appears in the dis-
play.
2 Press m or n to select the AM tun-
ing step.
Pressing m or n will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.

Switching the warning tone

If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press F to select WARN.
Press F repeatedly until WARN appears in the
display.
2 Press r to turn warning tone on.
WARN :ON appears in the display.
# To turn warning tone off, press q.
80
En

Switching the auxiliary setting

It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press F to select AUX.
Press F repeatedly until AUX appears in the
display.
2 Press r to turn auxiliary setting on.
AUX :ON appears in the display.
# To turn auxiliary setting off, press q.
Note
When this unit is connected to the DEQ-P7650,
you can switch to the AUX mode to analog or di-
gital. However, when you use AUX as the source,
make sure the AUX mode is set to analog. AUX
digital should not be used with this unit.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can turn the dimmer on or off.
1 Press F to select DIMMR.
Press F repeatedly until DIMMR appears in
the display.
2 Press r to turn dimmer on.
DIMMR:ON appears in the display.
# To turn dimmer off, press q.