Initial Settings; Adjusting Initial Settings; Setting The Clock; Setting The Fm Tuning Step - Pioneer DVH-P5850MP Operation Manual

Initial Settings

Adjusting initial settings

1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press F and hold until function name
appears in the display.
3 Press F to select one of the initial set-
tings.
Press F repeatedly to switch between the fol-
lowing settings:
ClockFM (FM tuning step)AM (AM tuning
step)WARN (warning tone)AUX (auxiliary
setting)DIMMR (dimmer)R-SP (rear out-
put and subwoofer controller)TEL (tele-
phone muting/attenuation)DSC-A (disc
auto)D_ATT (digital attenuation)A-RESET
(audio reset)
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down F until the unit turns off.
# When the multi-channel processor (e.g., DEQ-
P7650) is connected to this unit, you can operate
D_ATT and A-RESET instead of R-SP.

Setting the clock

Use these instructions to set the clock.
1 Press F to select clock.
Press F repeatedly until clock appears in the
display.
2 Press m or n to select the segment
of the clock display you wish to set.
Pressing m or n will select one segment
of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Press r or q to set the clock.
Pressing r will increase the selected hour or
minute. Pressing q will decrease the se-
lected hour or minute.

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press F to select FM.
Press F repeatedly until FM appears in the dis-
play.
2 Press m or n to select the FM tuning
step.
Pressing m or n will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Section
14
79
En