Automatic Playback Of Dvds; Setting Remote Control Code Type - Pioneer DVH-P5850MP Operation Manual

Section
13 Setting up the DVD player
3 Press NUMBER buttons to input the re-
gistered code number.
4 Click the joystick.
This enters the code number, and you can now
change the level.
# If you input an incorrect code number, the
icon is displayed. Press CLEAR and input the
correct code number.
# If you forget your code number, refer to If you
forget your code number on this page.
5 Move the joystick left or right to select
the desired level.
6 Click the joystick.
The parental lock level is set.
Note
Pressing RETURN takes you back to the previous
display.
If you forget your code number
Refer to Changing the level on the previous
page, and press CLEAR 10 times. The regis-
tered code number is canceled, letting you
register a new one.

Automatic playback of DVDs

When a DVDs disc with DVD menu is inserted,
this unit will cancel the DVD menu automati-
cally and start playback from the first chapter
of the first title.
! Some DVDs may not operate properly. If
this function is not fully operated, turn this
function off and start playback.
78
En
1 Move the joystick up or down to select
DVD AUTO PLAY in the
SET-UP MENU (GEN).
DVD AUTO PLAY is highlighted.
2 Click the joystick to turn automatic
playback on or off.
# When the automatic playback is on, you can-
not operate repeating play of DVD disc (refer to
Repeating play on page 28).
Setting remote control
code type
When the remote control operation switch is
set to DVD, changing the remote control code
type enables you to operate the Pioneer DVD
player by the supplied remote control. There
are three remote codes, code type A, code
type B and code type DVH. When using this
unit with a multi-DVD player (e.g. XDV-P9), se-
lect code A. When using this unit only, select
code DVH.
! With this unit, code B cannot be used.
1 Set the remote control selection switch
on the left side of the remote control to
the appropriate position with a pen tip or
other pointed instrument .
! If you select DVH mode, there is no need to
take the following procedure.
! If you select A/B mode, take the following
procedure and change the code type to the
appropriate type.
2 Press 7 and 0 on the remote control si-
multaneously to change the code type.
Initially, the code type is set to A. Each time
you press 7 and 0 simultaneously on the re-
mote control the code type switches between
A and B.