Section
05
Tuner
Listening to the radio
1
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
1 Band indicator
Shows which band the radio is tuned to, AM
or FM.
2 Signal level indicator
Shows the radio wave strength.
3 Frequency indicator
Shows to which frequency the tuner is
tuned.
4 Stereo (5) indicator
Shows when the frequency selected is
being broadcast in stereo.
5 Preset number indicator
Shows which preset has been selected.
1
Press SOURCE to select the tuner.
Press SOURCE until you see TUNER dis-
played.
2
Press BAND to select a band.
Press BAND until the desired band is dis-
played, F1, F2, F3 for FM or AM.
3
To perform manual tuning, press m or
n with quick presses.
The frequencies move up or down step by
step.
18
En
4 4 4
2
3
4
To perform seek tuning, press and hold
m or n for about one second and re-
lease.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pressing either
m or n with a quick press.
# If you press and hold m or n you can skip
5
broadcasting stations. Seek tuning starts as soon
as you release the buttons.
Note
When the frequency selected is being broadcast
in stereo the stereo (5) indicator will light.