Starting The Bios Setup Program; Modifying The Bios - Toshiba Qosmio G30 User Manual

TOSHIBA RAID
Starting, Modifying and Ending the BIOS Setup
Program

Starting the BIOS Setup Program

1. Switch on your computer while pressing the Esc key.
If Password = is displayed, enter the User Password and press the
Enter key.
Please refer to Chapter 6, the
about the User Password.
The "Check system. Then press [F1] key." message is
displayed.
2. Press the F1 key.
The BIOS setup program will start up.

Modifying the BIOS

1. Select the RAID ARRAY setting in the SYSTEM SETUP (3/3) screen.
Please refer to the operating instructions displayed in the settings screen.
2. The settings are explained as follows. Modify the settings as necessary.
Current State
Create State
Built-in HDD1
Built-in HDD2
Configuration status and settings
JBOD
1RAID-0
2RAID-0
RAID-1
UNKNOWN
No Drive
G-4
TOSHIBA Password
Shows the current hard disk status.
Modify the hard disk configuration. (Modifications
are made with this setting).
Status of the connected hard disk.
Status of the second hard disk.
No RAID settings. Windows cannot be installed
in this disk except for using recovery CD/DVD.
Including RAID settings. Windows can be
installed in this disk.
Set to RAID-0 for 2 hard disks. This cannot be
set in this computer (Current State Only).
Set to RAID-1 for 2 hard disks (Current State
Only).
A RAID status except for the above status and
settings (Current State Only).
No hard disks connected (Current State Only).
Utility, for details
User's Manual