Usb Device; Memory Expansion; Sound System - Toshiba Qosmio G30 User Manual

Troubleshooting

USB device

Refer also to your USB device's documentation.
Problem
USB device does not
work

Memory expansion

Refer also to Chapter 9,
memory modules.
Problem
Beep sounds.
(Two beeps, a dash
and a dot, for a
defective memory
module in slot A.
Three beeps, a dash
and two dots for slot B.
When both beeps
sound, both memories
in slot A and B are
defective.)

Sound system

Refer also to documentation for your audio devices.
Problem
No sound is heard
10-14
Procedure
Check for a firm cable connection between the
USB ports on the computer and the USB device.
Make sure the USB device drivers are properly
installed. Refer to your Windows XP
documentation for information on checking the
drivers.
If you are using an operating system that does
not support USB, you can still use a USB mouse
and/or USB keyboard. If these devices do not
work, make sure the USB KB/Mouse Legacy
Emulation item in HW Setup is set to Enabled.
If problems persist, contact your dealer.
Optional Devices, for information on installing
Procedure
Make sure the memory module installed in the
expansion slot is compatible with the computer.
If an incompatible module has been installed,
follow the steps below.
1. Turn off the power.
2. Disconnect the AC adaptor and all peripheral
devices.
3. Remove the battery pack.
4. Remove the memory module.
5. Install the battery pack and/or connect the AC
adaptor.
6. Turn on the power.
If problems persist, contact your dealer.
Procedure
Adjust the volume control dial.
Check the software volume settings.
User's Manual