Configuring The Execute-Disable Bit Capability; Starting The Bios Setup Program; Ending The Bios Setup Program - Toshiba Tecra A7 User Manual

Configuring the Execute-Disable Bit Capability and TPM
The configurations for the Execute-Disable Bit Capability and TPM are
carried out in the BIOS setup program.
Notes before using the BIOS Setup:
■
In normal cases, changes in system configuration should be made in
Windows using TOSHIBA HW Setup, TOSHIBA Password Utility,
TOSHIBA Power Saver, Device Manager, etc. If the configuration in the
BIOS setup program is different from the configuration in the Windows
utility, the configuration in the Windows utility takes priority.
■
Depending on the system, changes made to the system configuration
might not be reflected.
■
The settings in the BIOS setup program are not erased even if the
power supply is switched off. However, if the built-in battery
(RTC battery) runs out of power, the settings will revert back to their
default values.
■
The following item does not revert back to their default values:
■
■
■
Starting and Ending the BIOS Setup Program

Starting the BIOS Setup Program

1. Switch on your computer while pressing the F2 key.
If "
Enter key.
2. The BIOS setup program will start up
■
Select either the Execute-Disable Bit Capability or settings in the
security controller to make changes. Please refer to the operating
instructions displayed in the settings screen.

Ending the BIOS Setup Program

Save the changes and end the program.
1. Press the F10 key.
The "
[Yes] [No]
2. Select
The configured settings are saved and the BIOS setup program ends.
3. If you select
the BIOS setup program.
User's Manual
Password
HDD Password
Security controller.
Password = " is displayed, enter the user password and press the
Save configuration changes and exit now?
" message is displayed.
[Yes]
and Press the Enter key.
[No] and Press the Enter key, the screen will return to
HW Setup and Passwords
7-7