Cleaning The Spray Arms - Blomberg Dishwasher Instruction Manual

Cleaning the spray arms

Dirt or calcium residue may block the
nozzles on the spray arms. For this
reason, regularly check the spray
nozzles.
1. Lower spray arm
2. Upper spray arm
1. Remove the lower basket from the
machine.
2. Pull off the lower spray arm in an
upward direction (A).
3. Loosen the fastening screw of the
upper spray arm and pull off the
spray arm (B).
4. Clean the spray arms under
running water.
5. Replace the spray arms.
Ensure that the fastening screws are
screwed tight.
�
�
�
1032
�
Cleaning the filter inset in the water
inlet hose (depends on the model)
Dirt from deposits in the water pipes is
prevented by a filter in the water inlet
hose. Check the filter and the water
inlet from time to time.
1. Close the water tap and unscrew
the water inlet hose.
2. Take out the filter and clean it
under running water.
3. Replace the cleaned filter.
4. Fasten the water inlet hose to the
water tap again.
Check if the holes on the top of
the additional upper spray arm are
clogged. If they are clogged, remove
and clean them.
To remove them, slightly (1) push them
upwards and then turn clockwise (2).
To replace the impeller, seat it into its
slot, push slightly upwards and turn it
anticlockwise until it is securely fitted.
When the impeller is released, check if
it rotates without any obstruction.
�
36 GB
�