Changing A Program; Configuration Of Menus - Blomberg Dishwasher Instruction Manual

Quick and Silent Functions cannot
be selected concurrently. If the other
function is selected when either of
these functions is already selected,
your machine will warn you with
the Can not be selected together!
message. The last selected function
will become active and its indicator will
turn on. If you press the same function
button twice, you will notice that the
indicator will turn on with the first press,
and it will turn off and the selection will
be cancelled with the second press.
Different from the other functions,
the Tablet Deterg. Function will
remain selected unless you cancel
this function by pressing the relevant
button once again after you have
selected it. Only in cases of selecting
the "Prewash" and "Blink" programs in
which this function is not valid, you will
see that the function indicator is turned
off.
When you change the program while
one or more than one of the functions
apart from the Tablet Detergent
function are selected, you will see that
the relevant function indicator on the
display will turn off and the selections
will be cancelled. You will need to add
the suitable functions again for the
newly selected program.

Changing a Program

Press Start/Pause/Cancel Button
first to switch your machine into
pause mode if you want to change
your selection after you have started
the program. Switch to the desired
program by pressing the Selection
Buttons (7). Start the new program by
pressing Start/Pause/Cancel Button
again. Your new selection will resume
operation from the step in the previous
program (For example, if the previous
program was in rinsing step, the new one
will also start from the rinsing step).
If you want to run the newly selected
program from the very beginning, you
have to apply the cancellation process
first and then select a new program.

Configuration of menus

Machine Settings
You can use the Settings Menu to change
the Language, Screen Brightness,
Contrast, Display mode, Volume, Water
Hardness and Melody settings you are
going to use in the dishwasher or Restore
Factory Settings.
To enter into the "Settings Menu":
1. Press On/Off Button (1) to turn on
your dishwasher.
2. Press "Function" (4) and "Time
Delay" (5) buttons together for 3
seconds.
28 GB