LG F1200 Service Manual page 120

A. Target System Frame
This is for initializing the target phone. When you use this program to test F1200 phone, you
have to initialize target at first. To initialize target phone, select target (F1200 is default) and
COM port used at your computer and then click the Initialize button. If target initializing is ended
successfully, the box in red below the initialize button will turn into green.
B. RX AGC Test Frame
At this part, you can control receiver path of target phone.
Serving Freq. Setting (TCH)
You can set TCH of phone. The number means ARFCN of Traffic channel. You can change the
value by clicking arrow button by one step or just entering the number directly.
Beacon Freq. Setting (BCH)
You can set BCH of phone. The number means ARFCN of base station broadcasting channel.
AGC Value Setting
You can set AGC gain of phone. The number means gain of AGC amplifier in Rx path.
Power Measurement
The number means channel index according to pre-defined ARFCN. There are 12 pre-defined
ARFCNs within Rx band. 4 ARFCNs are for GSM and others for DCS,PCS. Clicking arrow
button to change number, you can see TCH and BCH ARFCN changed automatically. PM
window displays the power level measured in baseband chip. PM value is useful to calculate the
received absolute power. The unit of PM is dBd.
PM Start
You can measure Rx power that target received from test equipment. When you click this button
the result of power measurement displayed at PM blank in Power Measurement frame.
You can measure PM for all 12-channel indexes by changing Number and clicking PM Start.
Calculate
You have to do this work after measuring PM for all 12-channel indexes. When you click this
button, service software calculate the calibration data from measured 12 PM data.
Standalone
This button makes target operate in Rx mode continuously. Target will be operated under the
condition that you set. During continuous receiving mode, label of Standalone button is changed
to Stop. If you want stop receiving mode operating, click this button one more.
C. TX APC Test Frame
At this part, you can control transmit path of target phone.
Serving Freq. Setting (TCH)
You can set TCH of phone. The number means ARFCN of Traffic channel.
Beacon Freq. Setting (BCH)
You can set BCH of phone. The number means ARFCN of base station broadcasting channel.
12. SERVICE AND CALIBRATION
- 119 -