Maintenance - Craftsman 172.11702 Operator's Manual

MAINTENANCE

WARNING:
!
adjustments MUST be performed by a qualified service technician at a
Sears Service Center.
WARNING:
!
from the power source before performing any maintenance or cleaning.
It has been found that electric tools are subject to accelerated wear and possible
premature failure when they are used to work on fiber glass boats and sports cars,
wallboard, spackling compounds or plaster. The chips and grindings from these materials
are highly abrasive to electrical tool parts, such as bearings, brushes, commutators, etc.
Consequently, it is not recommended that this tool be used for extended work on any
fiberglass material, wallboard, spackling compound or plaster. During any use on these
materials, it is extremely important that the tool is cleaned frequently by blowing with
an air jet.
WARNING:
!
during power tool operations, or when blowing dust. If operation is dusty, also
wear a dust mask.
ROUTINE MAINTENANCE
WARNING:
!
based products, penetrating oils, etc. come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic, which may result in serious
personal injury.
Periodic maintenance allows for long life and trouble-free operation. A cleaning and
maintenance schedule should be maintained. As a common preventive maintenance
practice, follow these recommended steps:
WARNING:
!
from the power source before performing any maintenance or cleaning.
1. When work has been completed, clean the tool to allow smooth functioning of the tool
over time. Clean the tool with compressed air.
2. Use clean damp cloths to wipe the tool.
3. Keep the motor air openings free from oil, grease and sawdust or woodchips, and store
tool in a dry place.
LUBRICATION
Your Craftsman Pad Sander has been properly lubricated and is ready to use.
®
No further lubrication is needed under normal operating conditions. All bearings in the
sander are lubricated for the life of the tool.
To ensure safety and reliability, repairs, maintenance and
For your safety, ALWAYS turn off switch and unplug sander
Always wear safety goggles or safety glasses with side shields
DO NOT at any time let brake fluids, gasoline, petroleum-
For your safety, ALWAYS turn off switch and unplug sander
23